0 items added to cart

Deltana FDB278U10B Solid Brass 2 7/8-Inch Floor Door Bumper

  • Deltana FDB278U10B Solid Brass 2 7/8-Inch Floor Door Bumper

Deltana FDB278U10B Solid Brass 2 7/8-Inch Floor Door Bumper

CA$ 136.00 CA$ 81.60 Save: CA$ 54.40
CA$ 81.60 CA$ 136.00 You save: CA$ 54.40



  • 1
    • 1
    • 2
    • 3
    • 4
    • 5
    • 6
    • 7
    • 8
    • 9
    • 10
Delivery Time: 15-20 days
Delivery Time: 15-20 days

  • Tracked Shipping

  • Secure Payments

  • 10 Days Return

  • Country Of Origin: China
  • Package length: 4.0"
  • Package Width: 4.0"
  • Package Height: 4.0"
Read More
Read Less
See all Reviews

Customer Reviews

NOT 2-7/8" high - actually 2-1/2"Not as described. The height is only 2-1/2", not the 2-7/8" in the Amazon description. No instructions for installation, although it's pretty easy to figure out if you're the least bit handy. Otherwise, it's fine. Comes with mounting hardware for both wood or concrete subflooring. 3Exactly as describedThis door stop is a little taller than most which was perfect for my needs. Replaced old wood floor with new manufactured product which was thinner causing the door threshold to be a little higher than most. The box stores didn't have any this tall and this fit perfectly. 5Great Door Stop When Failure Is Not An OptionI used this door stop to protect the gas line and controller for water heater. Very solid, perfect height for my back door. Installation was easy once I figured out drill bits. I used a 3/8 concrete bit. Hole was too tight. I then used a 25/64 regular bit. Blew holes out with compressed air. The sleeve anchor went in with a few taps of a hammer. I used a M8-1.25 metric nut to set the anchor. 5GreatWorked for what I needed 5Very solid but pricey. I mounted to concrete floor ...Very solid but pricey. I mounted to concrete floor in my garage. I wish the instructions had listed the size drill bit that was needed. I ended up using the same size bit as the anchor but "wallered " it out, because the next size rotary hammer bit looked too big. I also used a tapcon on the secondary anchor (screw hole) just for extra security. So this thing will stop a 400lb man that's falling towards a cheeseburger. 4Fine product. Seems very solidFine product.Seems very solidIncludes screws that are needed to anchor downA little bit spendy though.If I need another I will purchase again.Do it! 4No more holes in wall from doorknobsAmazing solution for the doors that keep on opening wide and slam into the wall behind it. Looks neat and could screw through the regular carpeted floor to hold it's place. No more artistic holes in wall from doorknob banging into it. :) 5Good qualityExcellent 5Excellent Product. Excellent Price. Fast Shipping.Excellent door stop. Easy to install. No instructions and none needed... but here's mine for my WOODEN floor.1) Place on floor where you want to stop the door.2) Open your door to align the head of the door stop perfectly with your door.3) Mark around the base with a Sharpie, Pencil, etc. Also mark inside the screw hole in the rear.4) Measure 1" - 1/8" from the MIDDLE of the small screw hole to the CENTER of the stop. This is where the lag screw will go into the floor.5) Drill the SMALL hole (the rear hole) two (2) sizes SMALLER than the screw.6) Drill the CENTER hole two (2) sizes SMALLER than the lag screw.7) Screw the top of the lag screw into the bottom of the door stop.8) Screw the door stop down into your floor until it is flush with the floor and matches the drawing on the floor you made with your Sharpie or pencil.9) Insert the INCLUDED small screw into the hole in the rear and screw it down. 5Classy little brass door stopThis is as advertised and as several have mentioned does not include any instructions. It's not hard to figure out if you're even the slightest bit handy. I installed to tile which meant buying the correct drill bits (1/2" and 1/4") which together cost more than the stop but worth getting to do the job right and avoid cracking the tile. Total install time (excluding getting the bits) - 20 minutes 5
See All Reviews
  • Shipment tracking ID will be provided after your product(s) is dispatched.
  • The delivery date stated is indicative and subject to availability, payment authorization, verification, and processing.
  • In case your product(s) is not delivered due to an incorrect or invalid address, we will not be able to process any claims. However, we will notify you if it is returned to us.
  • Return or exchange requests can be made within 10 days of the delivery date.
  • To return or exchange any items, please email us at info@homeloft.ca, clearly mentioning your order number and our customer support team will guide you on the process.
  • To be eligible for return, products must be in the exact condition you received them in. All packaging material must be undamaged and unused with the price tags intact.
  • Orders can be cancelled before dispatch. If the order has already been dispatched, cancellation fees might be charged.
  • Due to the nature of the products that we sell, we will not be able to replace or refund unwanted items if they have been opened or any seals are broken.
  • The refund will not include the import duties or the cost of delivery or return postage.
  • If your refund is approved, then it will automatically be credited to the original method of payment, within 7-10 days.
  • HomeLoft reserves the right to alter and enforce this Return and Refund Policy at any time without having to serve a prior notice to users.

Recently Viewed Products

Back to top
Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page

Be the first to know Home Loft

Log in to discover our collection